Thermostat Mahle or MotoRad

Mine has been chilling little to no problem so far in 20-30° PA

Sometimes going down long hills engine braking will close the thermostat and will warm up to 200, but then opens back up

I replaced it with the motorad thermostat that opens 10° lower

I’ve installed Borg Wagner thermostats and those always failed until I installed a Mahle one which never failed. For some reason any other brand will get stuck open and the engine will never get up to temp.

Motorad (SNN-2000-195) 195 thermostat for quite awhile now. Zero issues.\n\nI did try something that claimed to be a Mopar t-stat my last upgrade and it wouldnt open up until about 225 degrees. It was like 40 bucks too. So i went back to the Motorad (SNN-2000-195)

Update: replacing the MotoRad thermostat it had in it with an OEM one fixed it and it sits at 1/3rd like it should.

I had a brand new mahle one with the connector wired in reverse for constant. Kept blowing a fuse. Returned it for a replacement and worked fine.

I had a lot of trouble this summer myself with a bad thermostat. I found a stant super stat that used to be one of the best that they don\u2019t make any anymore, but it caused me some trouble.,I had no choice I went with a motorad 195, seems to be all right It\u2019s been about four months now.

Hatte auch schon ein Mahle Thermostat das kurz nach eimbau defekt war. Dannach ein Originales von BMW rein und seit dem wi3der keine Probleme.

I bought a Motorad 7908203 Thermostat and replaced it. Got all the air out of the system after replacing and all seemed good but now, my car only heats up to the correct temp when idle and when I start to drive is when my car starts to cool down closer to C again and doesn’t heat up any further.

Don't get the Motorad that includes the thermostat housing, because that one is junk, and the thermostat housing is not OEM sized.

Don't get the Motorad that includes the thermostat housing, because that one is junk, and the thermostat housing is not OEM sized.